The best way to Install an Porcelain Sink

Tagged As:

Porcelain sinks, using a ceramic area used to your base of cast-iron, were popular from the 1890s until the 1920s and have never completely fallen favor. It’s possible for you to take one of three methods in installing a porcelain sink depending which model of porcelain sink you purchase. Most frequently, you may drop a “self-rimming” sink to the tile counter, therefore the lip of the sink rests on the very top of the tile. You can alternatively set a “tile-in” design flush with all the tile; or operate the tiles on the fringe of of a “counter over” sink. Countertop planning is very comparable for every model.

Tape the sink template to the root of the counter, an average of ¾-inch plywood. Mark the outline to be cut from the plywood. Drill a hole on the interior edge of the outline. Drop the fine toothed blade of a jig-saw to the hole and cut a hole out centered on the outline. For best results on openings with rounded corners -inch hole saw to eliminate each corner in the start.

Lay a panel of cement backer board on the opening. Scribe the outline you just cut out onto the rear of the board by opening a cupboard door and achieving up with a carpenter’s pencil. Remove the backer board and suit an cutting blade to your own jigsaw. Cut together with the jigsaw on the outline.

Trowel Thinset mortar using a trowel on the plywood. Press the cement backer board set up together with the mortar. Screw it cement board screws put every 8″. Let the mortar established for two hrs.

Mount the faucet and strainer baskets to the sink after the manufacturer’s guidelines.

Latex mastic using tile and a trowel the counter-top right up to the edge that is cut-out in the event that you plan to fall in a self-rimming sink, which sits atop a ring of silicone sealant as well as the tile. Alternatively spot painter’s tape on the fringe of of a tile-in sink, use 1-inch of sealant a-T every corner, lay the sink in the cut-out, and tile to within 3/8 inch of the sink edge. Fill last row of tile and the gap involving the sink . For counter-over sinks, tighten the mounting clip included in the sink’s rim to the plywood-backer board sandwich and cover the very top of the clip with mastic as well as a row of bullnose tile.

Complete the sink installation by connecting the faucet to the provide lines grouting involving the tiles and twisting the P trap on the drain.

See related