It does little good to crank up the heat in your house to have the bulk of it escape through small cracks in the window. Winterizing your house doesnât need to mean making it unsightly. The use of heat-shrink plastic provides a a good seal all around your window that air can not get in or out of and is obvious enough to predict and allow sunlight in. Easy to apply, the use of plastic is a cheap way to reduce power costs this winter.
Wipe down the window-sill and body using a clean moist cloth. Any grime might cause the plastic to not seal correctly. Make sure the window is latched and closed. Dry any dampness using a fabric that is second.
Line the exterior edge of the molding across the window-frame with strips of double-sided tape. Don’t eliminate the layer that is leading just.
Measure the window using a measuring tape both vertically and horizontally.
Cut a bit of heat-shrink plastic that’s broader and an inch longer in relation to the measurements you took for the window.
Peel away the protective layer in the double-sided tape.
Place the plastic on the window, pressing it. Leave a little of the plastic hanging on the edge of the tape. Start operating on top of the window and pull the plastic in the underside.
Run your fingers over the tape to make sure that the plastic is caught to it completely across the window.
Turn to the large environment in your hair dryer and operate it over the sheet that is entire. Hold three to four inches above the window to the hairdryer and keep it shifting; by keeping the hairdryer over one region of the plastic for also long, it will be molten. The wrinkles is going to be gone after you have heated the complete window and also the plastic is likely to be taut.
Cut a-way excessive plastic from the edges having a box-cutter or utility knife to tidy up it.